Differences

This shows you the differences between two versions of the page.

--- hardware:modules:c1002s [2019/02/26 09:35]
rsharma
+++ hardware:modules:c1002s [2021/09/13 05:57]
@@ Line 1: / Line 1: @@
-======C1002s Current Sensor Module======
-{{ 20180907_c1002s.jpg?400|C1002s}}The C1002s 100A Current Sensor Module is one of the Modbus-compatible modules that can be used to measure bidirectional DC currents up to 100A and is ideal for off-grid setups. Using one channel to measure solar current and one channel for load current, it is possible to create a coulomb counting based algorithm to accurately estimate battery capacity.
-The current transformers are a bidirectional, hall effect, open loop device based on the measuring principle of the hall effect, with a galvanic isolation between primary and secondary circuit. It provides accurate electronic measurement of DC currents in the range of 0—±150. The loop hole size is 21 mm.
-It can be configured and controlled by any Modbus RTU master device over RS-485.
-The C1002s Module can be used for any application in monitoring DC Current, such as:
-  * **Battery Monitoring** - Measure charge/discharge current for batteries
-  * **Panel Monitoring** - Measure current output of solar panels
-  * **Pump Monitoring** - Measure current output of pump VFD
-[[c1002s_intro|Overview]] - Introduction to the features of the C1002s
-{{c1002s_spec_sheet.pdf|DataSheet}}

Wattmon Documentation Wiki